Using The Co-Mini Clone Cable; Using The Pc-Mini Programing Cable; Preparations - AOR AR-Mini Operating Manual

PREPARATION AND BASIC USAGE
Using the CO-mini Clone
Cable
1
Turn the AR-mini off.
Earphone
2
Remove the AR-mini earphone
jack cap.
3
Turn the power on while holding
down FUNC and
• "RX-TX" will be displayed.
4
Press the receiver's SCAN key.
("R" will be displayed.)
5
Press the transmitter's MODE key.
("T" will be displayed.)
6
Confirm "PASS" is displayed when
the cloning is completed.
• If "NPASS" is displayed, the cloning
has failed. Repeat the procedure
from step 3.
Note:
• Do not remove the plug by
tugging at the cable. The cable
may become disconnected and
thereafter malfunction.
• Turn the power off before
connecting or removing the cable.
22
Plug
jack
key.
Using the PC-mini
Programing Cable

Preparations

◆ Installing special software
Access the download page on our
web site and download the software
according to the explanation
provided there.
URL: http://www.aorja.com/ar-mini/
Run the downloaded file and perform
setup.
Caution:
Although this software is provided
free of charge, do not make any
illegal copies.
◆ Installing the USB driver
PC-mini requires a special USB driver.
Before connecting PC-mini to the PC,
ensure that you have installed the USB
driver.
This USB driver can be downloaded
from the following URL.
URL: http://www.aorja.com/ar-mini/
CP210x_VCP_Win2K_XP_S2K3.
exe
or
URL: http://www.silabs.com/
* Download the VCP Driver kit.