Clone (Copy) Data Between Two Ar8000; Clone (Copy) In Newuser Status; Clone (Copy) In Expert Status - AOR AR8000 Operating Manual

(19) Clone (copy) data between two AR8000 receivers
It is possible to clone (copy) selected or ALL data from one AR8000 to another
AR8000 receiver. This is a useful facility when two friends each have the
AR8000 receiver and wish to share data.
The optional CU-8232 interface is
required along with the necessary
cables for connecting two AR8000
receivers together. Further
information will be provided with
the optional CU-8232 interface unit.
There are two levels of clone
(copy), NEWUSER and EXPERT.

19-1 CLONE (copy) in NEWUSER status

Connect the two AR8000 receivers together using the optional CU-8232
interface and cables. Decide which receiver is going to SEND the data and
which is going to RECEIVE. You cannot specify what data is to be transferred,
ALL data must be sent.
The process of copying data is initiated using the "SET COPY" menu which is
accessed by pressing [FUNC] [0] while in NEWUSER status.
Use the [DIAL] to select "SEND-MODE" for the receiver which will SEND the
data and "RCV-MODE" for the receiver which will RECEIVE the data.
Press [CLEAR] now to suspend the copy process. Should you press
[CLEAR] while copying, the receiver may become operationally unstable.
Press [ENT] to start the copy process. The display "=>" will appear on the
LCD to indicate that COPY is in progress.
The legend "=" will increase in length as the copy process progresses "===>".
Each line of "===========" will add one S-meter reading to the fourth line of
the LCD and the copy process ends with S-8.
It will normally take about 5 to 6 minutes to complete copy between receivers.
At the end of the copy process the receiver will return to normal display as
before the copy process was initiated.
19-2 CLONE (copy) in EXPERT status - additional facilities
Additional facilities become available in EXPERT status.
Ensure that the receiver is in EXPERT status. If it is not press [FUNC]
[LOCAL].