Plu Page Programming; Discount (-%) Or Add-On (+%) Percents; Paid Out (Po) Or Received On Account (Ra) Amounts - Olivetti ECR 6920 F User Manual

4. Enter the letters or characters of the string you wish to
define and then press
personalize the next line.
5. Repeat steps 3 and 4 if you wish to program the
remaining programmable header or footer lines.
6. Press to exit.
Example: Change the third line of the default header to
SALES ON NOW using the CAPS Character Table.
Type/Press:
Switch to Recipt header
definition mode

PLU Page Programming

Your cash register comes with 126 PLUs organized into the
following 3 levels (or pages): PLUs 1 to 42 on PLU Page 1,
PLUs 201 to 242 on PLU Page 2 and PLUs 301 to 342 on PLU
Page 3. You can redefine the PLU page contents by assign-
ing the range of 42 PLUs wanted to each page or level.
1. Control lock key position: PRG
2. Type the first PLU number [1 to 1500] of the range of
42 PLUs that you wish to assign and press the
corresponding PLU Page key
3. If the newly assigned PLUs are not programmed with
a price, proceed to do so as explained in section
"Programming Fixed Price Look-Ups (PLUs)".
Example: Assign PLU range 51 to 92 to
Type/Press:
Range start PLU

Discount (-%) or Add-on (+%) Percents

The and keys can be set up to apply a predefined
percentage discount or percentage add-on. The rate can be
applied to an individual item or to the sales transaction total.
You can also specify a limit for the add-on or discount
percentage, so that add-ons or discounts above the limit
percentage will be disabled.
The procedure for both keys is the same:
1. Control lock key position: PRG.
10
. You are now prompted to
Receipt header
line selection
Exit
Confirm entered
header
, or
.
PLU page or level
2. Type the [numbers] representing the desired
percentage rate. Up to four digits ranging from 0 to
99.99 can be specified. Two digits must be placed
before the decimal point and two must be placed after.
3. Define whether the percentage rate is a discount or an
add-on by entering the related code indicated below:
0 = Percent add-on
1 = Percent discount
4. Enter the [4-digit] percentage rate limit. A value in the
range from 0 to 99.99 can be used. Two digits must be
placed before the decimal point and two must be placed
after. The default is 9999.
NOTE: When the rate limit is set to 0000, it is not possible
to override the predefined rate associated with the key.
5. Press or
the respective key.
Example: Program the
add-on rate and the
discount rate, without limitation.
Type/Press:
Units Decimals
No limitation
.
Decimals
Units
No limitation
Paid Out (PO) or Received on Account (RA)
Amounts
A High Digit Lock Out (HDLO) and receipt print status can be
assigned to the
used for Paid out and Received on account transactions. By
assigning an HDLO status, you make sure that Paid out and
received on account amounts do not exceed a maximum
value. By programming the receipt print status, you decide
whether or not the receipt header is printed on PO and RA
receipts.
to assign the rate and function to
key with a standard 5.50%
key with a standard 10%
Percent
add-on code
Percent
discount code
and keys when these keys are