Dynamic Ip Address; Figure 22 Interface Setup > Internet (Dynamic Ip) - ZyXEL Communications P-660RU-Tx User Manual

Table 11 Interface Setup > Internet (continued)
LABEL
QoS
ATM QoS
PCR
SCR
MBS
Encapsulation
SAVE
DELETE

7.2.1 Dynamic IP Address

In the Interface Setup > Internet screen, select Dynamic IP Address from
the ISP field to display the following screen.
Figure 22 Interface Setup > Internet (Dynamic IP)
P-660RU-Tx User's Guide
DESCRIPTION
Select CBR (Continuous Bit Rate) to specify fixed (always-on)
bandwidth for voice or data traffic. Select UBR (Unspecified Bit Rate)
for applications that are non-time sensitive, such as e-mail. Select
rtVBR (real-time Variable Bit Rate) for applications with bursty
connections that require closely controlled delay and delay variation.
Select nrtVBR (non real-time Variable Bit Rate) for connections that
do not require closely controlled delay and delay variation.
Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find
the Peak Cell Rate (PCR). This is the maximum rate at which the
sender can send cells. Type the PCR in this field.
The Sustain Cell Rate (SCR) sets the average cell rate (long-term)
that can be transmitted. Type the SCR, which must be less than the
PCR. Note that system default is 0 cells/sec.
Maximum Burst Size (MBS) refers to the maximum number of cells
that can be sent at the peak rate. Type the MBS, which is less than
65535.
Select the connection type supported by your ISP. The next fields vary
depending on what connection type you use. See the following
sections for more details.
Click this to save your changes.
Click this to restore the PVC to default settings.
Chapter 7 Internet Setup
63