Figure 90Red Hat 9.0: Dynamic Ip Address Setting In Ifconfig-Eth0; Figure 91Red Hat 9.0: Static Ip Address Setting In Ifconfig-Eth0; Figure 92Red Hat 9.0: Dns Settings In Resolv.conf - ZyXEL Communications P-660R-Tx v2 Series User Manual

1 Assuming that you have only one network card on the computer, locate the
configuration file (where
eth0
configuration file with any plain text editor.
•
Figure 90 Red Hat 9.0: Dynamic IP Address Setting in ifconfig-eth0
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=dhcp
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
•
Figure 91 Red Hat 9.0: Static IP Address Setting in ifconfig-eth0
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=192.168.1.10
NETMASK=255.255.255.0
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
2 If you know your DNS server IP address(es), enter the DNS server information in the
file in the
resolv.conf
two DNS server IP addresses are specified.
Figure 92 Red Hat 9.0: DNS Settings in resolv.conf
nameserver 172.23.5.1
nameserver 172.23.5.2
3 After you edit and save the configuration files, you must restart the network card. Enter
./network restart
shows an example.
is the name of the Ethernet card). Open the
eth0
If you have a dynamic IP address, enter
field. The following figure shows an example.
If you have a static IP address, enter
field. Type = followed by the IP address (in dotted decimal
IPADDR
notation) and type
NETMASK
following example shows an example where the static IP address is
192.168.1.10 and the subnet mask is 255.255.255.0.
directory. The following figure shows an example where
/etc
in the
/etc/rc.d/init.d
P-660R-Tx v2 Series User's Guide
in the
dhcp
in the
static BOOTPROTO=
= followed by the subnet mask. The
directory. The following figure
ifconfig-
BOOTPROTO=
147