ZyXEL Communications P-660RU-Tx User Manual page 117

Table 33 Access Management > ACL (continued)
LABEL
Application
Interface
Access
Control
Listing
SAVE
DELETE
CANCEL
P-660RU-Tx User's Guide
DESCRIPTION
Select the service through which the computer can access the device.
• If you want to allow a user to connect to the P-660RU-Tx using the
web configurator, select Web.
• If you want to allow a user to connect to the P-660RU-Tx using Telnet,
select Telnet.
• If you want to allow a user to upload firmware to the P-660RU-Tx,
select FTP.
• If you want to allow an administrator to send SNMP commands, select
SNMP.
• If you want to allow a user to find the P-660RU-Tx on the network (for
troubleshooting purposes, for example), select Ping.
• Select ALL to allow access for all services. You cannot select a
combination of services.
Select the port through which you can access the device. Select Both for
access via either port. If you configure 0.0.0.0 ~ 0.0.0.0 Secure IP
Address, ALL services and WAN interface, you will not be able to access
the device at all from the LAN unless you configure another rule for LAN
access.
The summary table displays the configured parameters for the selected
rule.
Click this so save your changes.
Select an access control rule index number and click this to remove it.
Click this to restore your previously saved settings.
Chapter 14 Access Control
117