ZyXEL Communications P-660RU-Tx User Manual page 121

Table 34 Access Management > Filter (IP/MAC) (continued)
LABEL
Direction
IP/MAC Filter Rule Editing
IP/MAC Filter Rule
Index
Rule Type
Active
Source IP Address
Subnet Mask
Port Number
Destination IP Address
Subnet Mask
Port Number
Protocol
MAC Address
Rule Unmatched
IP Filter Listing
IP Filter Set Index
Interface
Direction
#
Active
Src Address/Mask
Dest IP/Mask
Src Port
Dest Port
P-660RU-Tx User's Guide
DESCRIPTION
Apply the filter to Both, Incoming or Outgoing traffic
direction.
Select the index number of the filter rule.
Select IP or MAC type to configure the rule.
Use the IP Filter to block traffic by IP addresses.
Use the MAC Filter to block traffic by MAC address.
Use this field to enable or disable the rule.
Enter the source IP address of the packets you wish to filter.
This field is ignored if it is 0.0.0.0.
Enter the IP subnet mask for the source IP address
Enter the source port of the packets that you wish to filter. The
range of this field is 0 to 65535. This field is ignored if it is 0.
Enter the destination IP address of the packets you wish to
filter. This field is ignored if it is 0.0.0.0.
Enter the IP subnet mask for the destination IP address.
Enter the destination port of the packets that you wish to filter.
The range of this field is 0 to 65535. This field is ignored if it is
0.
Select ICMP, TCP or UDP for the upper layer protocol.
This field is only available when you select MAC in the Rule
Type field.
Enter the MAC address of the packets you wish to filter.
Select the action for a packet not matching the rule.
Select Forward to forward traffic immediately and skip
checking the remaining rules. Select Next to check the next
rule.
Select the index number of the filter set from the drop-down list
box.
This is the interface that the filter set applies to.
The filter set applies to this traffic direction.
This is the index number of the rule in a filter set.
This field shows whether the rule is activated.
This is the source IP address and subnet mask when you select
IP as the rule type.
This is the MAC address when you select MAC as the rule type.
This is the destination IP address and subnet mask.
This is the source port number.
This is the destination port number.
Chapter 15 Filters
121