Table 1 LED Descriptions
LED
USB
Refer to the Quick Start Guide for information on hardware connections.
1.6 The RESET Button
If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to "1234".
1.6.1 Using the Reset Button
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
1.7 USB Port
The USB port is useful if you have an USB-enabled computer that does not have a
network interface card for attaching to your Ethernet network. See the following
sections for USB driver installation procedures in your operating system.
System Requirements
• Windows 98 (Second Edition), Windows Me (Millennium Edition), Windows
2000, Windows XP or Windows Vista
• An available USB port
Note: Install the USB driver before you connect the P-660RU-Tx to the USB port.
P-660RU-Tx User's Guide
COLOR STATUS
DESCRIPTION
Green
On
There is a USB connection.
Blinking
The P-660RU-Tx is sending or receiving data via the
USB port.
Off
There is no USB connection.
Chapter 1 Introducing the P-660RU-Tx
29