Figure 114 Red Hat 9.0: Dynamic Ip Address Setting In Ifconfig-Eth0; Figure 115 Red Hat 9.0: Static Ip Address Setting In Ifconfig-Eth0; Figure 116 Red Hat 9.0: Dns Settings In Resolv.conf - ZyXEL Communications P-660R-D Series User Manual

Figure 114 Red Hat 9.0: Dynamic IP Address Setting in ifconfig-eth0

DEVICE=eth0
ONBOOT=yes
BOOTPROTO=dhcp
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
•

Figure 115 Red Hat 9.0: Static IP Address Setting in ifconfig-eth0

DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=192.168.1.10
NETMASK=255.255.255.0
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
2 If you know your DNS server IP address(es), enter the DNS server information in the
file in the directory. The following figure shows an example where two DNS server IP
/etc
addresses are specified.

Figure 116 Red Hat 9.0: DNS Settings in resolv.conf

nameserver 172.23.5.1
nameserver 172.23.5.2
3 After you edit and save the configuration files, you must restart the network card. Enter
in the
restart /etc/rc.d/init.d
Appendix D Setting up Your Computer's IP Address
If you have a static IP address, enter
= followed by the IP address (in dotted decimal notation) and type
IPADDR
= followed by the subnet mask. The following example shows an
NETMASK
example where the static IP address is 192.168.1.10 and the subnet mask is
255.255.255.0.
directory. The following figure shows an example.
P-660R-D Series User's Guide
in the
static BOOTPROTO=
field. Type
resolv.conf
./network
15