Figure 74 Ftp Session Example; Table 44 General Commands For Gui-Based Ftp Clients - ZyXEL Communications P-660RU-Tx User Manual

Chapter 22 Firmware
Enter "bin" to set transfer mode to binary.
5
Use "get" to transfer files from the P-660RU-Tx to the computer, for example,
6
"get rom-0 config.rom" transfers the configuration file on the P-660RU-Tx to
your computer and renames it "config.rom". See earlier in this chapter for more
information on filename conventions.
Enter "quit" to exit the ftp prompt.
7
FTP Command Configuration Backup Example
This figure gives an example of using FTP commands from the DOS command
prompt to save your device's configuration onto your computer.

Figure 74 FTP Session Example

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Configuration Backup Using GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-
based FTP clients.

Table 44 General Commands for GUI-based FTP Clients

COMMAND
Host Address
Login Type
Transfer Type
Initial Remote
Directory
Initial Local Directory
156
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied
to the server for anonymous access. Anonymous logins will work
only if your ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary
mode.
Specify the default remote directory (path).
Specify the default local directory (path).
P-660RU-Tx User's Guide