ZyXEL Communications P-660RU-Tx User Manual page 145

Table 40 Access Management > CWMP (continued)
LINK
Port
UserName
Password
Periodic
Inform
Interval
SAVE
CANCEL
P-660RU-Tx User's Guide
DESCRIPTION
The default port for access to the P-660RU-Tx from the management server
is the HTTP port, port 80. If you change it, make sure it does not conflict
with another port on your network and it is recommended to use a port
number above 1024 (not a commonly used port). The management server
should use this port to connect to the P-660RU-Tx. You may need to alter
your NAT port forwarding rules if they were already configured.
The user name is used to authenticate the management server when
connecting to the P-660RU-Tx. Type a user name of up to 255 printable
characters found on an English-language keyboard. Spaces and characters
such as @#$%^&*()_+ are allowed.
The password is used to authenticate the management server when
connecting to the P-660RU-Tx. Type a password of up to 255 printable
characters found on an English-language keyboard. Spaces are not
allowed.
Select Activated to have the P-660RU-Tx periodically send information to
the management server (recommended if CWMP is enabled) or select
Deactivated to not have the P-660RU-Tx periodically send information to
the management server
The interval is the duration in seconds for which the P-660RU-Tx must
attempt to connect with the management server to send information and
check for configuration updates. Enter a value between 1 and 86400
seconds.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 19 CWMP
145