Fluke CombiScope PM3370B User Manual page 259

6 - 42
RECALL SETUP
Purpose:
To recall an internally stored setup from one of 10 setup registers. This setup must
have been stored in the oscilloscope manually or with the Save Setup (SS)
command.
The command performs the same as the frontpanel key SETUPS together with
the softkey RECALL.
Command:
"RS" pds
<setup reg>
Response:
acknowledge
Note: <acknowledge> will be sent after the internal setup has been completed.
Example:
100 PRINT #1,"RS";5
110 GOSUB 1000
setup reg
represents the setup register number ranging from 1...10
CR
:'Recall setting 5
:'Sync on acknowledge
THE CPL PROTOCOL
CR
RS