THE CPL PROTOCOL
IDENTIFICATION
Purpose:
Returns the identification of the oscilloscope. It gives information about the model
number, the version numbers of all software modules and the installed options.
This Identification (ID) command gives the same information as can be read from
the oscilloscope screen after pressing the frontpanel knob UTILITY and the
softkey MAINTENANCE.
Command:
"ID"
Response 1:
acknowledge
Response 2:
identity string
Note:
The items in the identity string are separated by a ';'(ASCII 59)
Example:
100 PRINT #1,"ID"
110 GOSUB 1000
120 INPUT #1,ID$
130 PRINT ID$
CR
CR
CR
:'Send command
:'Sync on acknowledge
:'Input Identity string
:'Print Identity string
6 - 13
ID