THE CPL PROTOCOL
GO to LOCAL
Purpose:
Puts the oscilloscope in the Local State. In the Local State, all oscilloscope
functions are accessible via the front panel buttons and knobs.
The Go to Local (GL) command performs the same function as pressing the
STATUS/LOCAL key on the front panel of the oscilloscope, when the oscilloscope
is in the Remote State (Refer also to "Go to Remote" and "Local Lockout").
Command:
"GL"
Response:
acknowledge
Example:
100 PRINT #1,"GL"
110 GOSUB 1000
Local, Remote, Remote+Local Lockout States
power-on
Local State
CR
CR
:'Send command
:'Sync on acknowledge
"Go to Remote"
"Go to Local"
"Reset Instrument"
<STATUS/LOCAL button>
"Go to Local"
"Reset Instrument"
Remote State
"Local Lockout"
Remote with
Local Lockout
State
6 - 11
GL