Fluke CombiScope PM3370B User Manual page 178

5 - 58
REMOTE CONTROL IEEE 488.2
Description:
An IEEE 488.2 Interface is available as an option. This interface can be used to
control oscilloscope functions by an external computer. All of the oscilloscope's
current settings can be read by the computer.
The programming language is called SCPI (Standard Commands for
Programmable Instruments). SCPI is an IEEE standardized language designed
for remote control of programmable test and measuring equipment. General
information for SCPI and the instructions are located in a separate programming
manual. The 24-pole connector and its connections are shown in the figure below.
For correct functioning in a IEEE 488 environment, the oscilloscope's device
address must be selected. This is done in the UTILITY REMOTE CONTRL menu
with the TRACK control. This menu is reached via the key sequence 'UTILITY >>
REMOTE CONTRL'. To change the IEEE settings, first select IEEE with the
'RS-232 IEEE' softkey.
Operation of front key STATUS LOCAL
passes the control of the oscilloscope from
the interface (remote) to the front keys
(local).
Key sequence:
REMOTE
UTILITY
SETUP
STATUS
LOCAL
TRACK
Control to select the IEEE device address.
ST6075
9303
Key to switch from remote to local
FUNCTION REFERENCE
DAV DIO4 DIO2
SHIELD SRQ NDAC
NR
ATN IFC FD EO1 DIO3 DIO1
12
24
GND GND GND REN DIO7 DIO5
11 9 7
LOGIC GND GND GND DIO8 DIO6
GND 10
8 6
1
13
ST6064