To Verify Basic Oscilloscope Operation - Agilent Technologies 6000 Series User Manual

C A U T I O N

To verify basic oscilloscope operation

6000 Series Oscilloscope User's Guide
Maximum input voltage for analog inputs:
CAT I 300 Vrms, 400 Vpk; transient overvoltage 1.6 kVpk
CAT II 100 Vrms, 400 Vpk
with 10073C or 10074C 10:1 probe: CAT I 500 Vpk, CAT II 400 Vpk
1 Press the Save/Recall key on the front panel, then press the
Default Setup softkey. (The softkeys are located directly below
the display on the front panel.) The oscilloscope is now
configured to its default settings.
2 Connect an oscilloscope probe from channel 1 to the Probe
Comp signal terminal on the front panel.
3 Connect the probe's ground lead to the ground terminal that
is next to the Probe Comp terminal.
4 Press Autoscale.
5 You should see a waveform on the oscilloscope's display
similar to this:
Getting Started 1
23