Delay And Phase Measurements - Agilent Technologies 6000 Series User Manual

Delay and Phase Measurements

6000 Series Oscilloscope User's Guide
Digital channel measurements
Automatic measurements Phase, and Delay are not valid for digital channels on
the mixed-signal oscilloscope or for the math FFT function. The two sources
defined in the phase and delay measurement must be turned on.
Delay
Delay measures the time difference from the selected edge on
source 1 and the selected edge on source 2 closest to the trigger
reference point at the middle threshold points on the
waveforms. Negative delay values indicate that the selected
edge of source 1 occurred after the selected edge of source 2.
Source 1
Source 2
1 Press the Quick Meas&Select and select Delay. Press the
Settings softkey to select the source channels and slope for
the delay measurement.
The default Delay settings measure from the rising edge of
channel 1 to the rising edge of channel 2.
2 Press the Measure Delay softkey to make the measurement.
Making Measurements
Delay
5
191