Agilent Technologies 6000 Series User Manual page 295

Trigger out
10 MHz ref in/out
Kensington lock
Power requirements
Line voltage range
Line frequency
Power usage
Environmental characteristics
Ambient temperature
Humidity
Altitude
Vibration
Shock
Pollution degree2
Indoor use
Other
Measurement categories
Regulatory information
Supplementary information
6000 Series Oscilloscope User's Guide
When "Triggers" is selected (delay ~17 ns)
0 to 5 V into open circuit
0 to 2.5 V into 50
When "Source Frequency" or "Source Frequency/8" is selected
0 to 580 mV into open circuit
0 to 290 mV into 50
Max frequency output:
350 MHz (in Source Frequency mode when terminated in 50 )
125 MHz (in Source Frequency/8 mode when terminated in 50 )
TTL out, 180 mV to 1 V amplitude with 0 to 2 V offset
Connection on rear panel for security
~Line 120 W max, 96-144 V/48-440 Hz, 192-288 V/48-66 Hz, automatic selection
50/60 Hz, 100-240 VAC; 440 Hz, 100-132 VAC
110 W max
Operating –10 °C to +55 °C; non-operating –51 °C to +71 °C
Operating 95% RH at 40 °C for 24 hr; non-operating 90% RH at 65 °C for 24 hr
Operating to 4,570 m (15,000 ft); non-operating to 15,244 m (50,000 ft)
Agilent class B1 and MIL-PRF-28800F; Class 3 random
Agilent class B1 and MIL-PRF-28800F; (operating 30 g, 1/2 sine, 11-ms duration,
3 shocks/axis along major axis. Total of 18 shocks)
Normally only dry non-conductive pollution occurs.
Occasionally a temporary conductivity caused by condensation must be expected.
Rated for indoor use only
CAT I: Mains isolated
CAT II: Line voltage in appliance and to wall outlet
Safety IEC 61010-1:2001 / EN 61010-1:2001
Canada: CSA C22.2 No. 1010.1:1992
UL 61010B-1:2003
The product herewith complies with the requirements of the Low Voltage Directive
73/23/EEC and the EMC Directive 89/336/EEC, and carries the CE-marking accordingly.
The product was tested in a typical configuration with HP/Agilent test systems.
Characteristics and Specifications 9
295