Sears Kenmore 385.19030 Owner's Manual page 20

(_
Mode Key
When the power switch is turned on, patterns
#1-#10 will be selected when the upper LED light
comes on.
Press the mode key to change to the numeric
stitch selection mode (patterns #11-#30)..
=_' B H1-3 can be selected directly in both modes..
(_) Stitch Width Control Key
Stitch width and stitch length will be indicated on
the liquid crystal display.
'_' To decrease the stitch width, press the" -" key.
'_' To increase the stitch width, press the" +" key.
(_) Stitch Length Control Key
Stitch width and stitch length will be indicated on
the liquid crystal display.
'_: To decrease the stitch length, press the "-" key.
'_' To increase the stitch length, press the" +" key
(_ Memory Key
Use the memory key to create a sequence of
decorative stitches. Press the memory key after
you select each stitch in the sequence.
For example, to create the sequence 27, 27, 29,
29, as shown to the right:
e Select pattern 27, then press Memory twice.
e Select pattern 29, then press Memory twice..
The sequence will repeat itself when it gets to
the end°
You can program a sequence up to 50 stitches
long.
'_ Stitch pattern #2 and the buttonhole stitches
(BH 1-3) cannot be memorized.
Clear Key
If a wrong pattern is memorized, pressing this
key will immediately clear it (like a "backspace"
key).
The clear key deletes all memorized stitch
patterns at one time after sewing has started.
® 1
I
27 27 29 29
12