In the M8000/M9000 servers and when the takeover IP address has been
■
disabled by setnetwork(8) command, nothing will be displayed even though
the takeover IP address is specified by the shownetwork(8) command.
The setnetwork(8) command configures a network interface used by the XSCF.
■
EXAMPLES
EXAMPLE 1
XSCF>
xscf#0-lan#1
Link encap:Ethernet
inet addr:192.168.10.11
UP BROADCAST RUNNING MULTICAST
RX packets:54424 errors:0 dropped:0 overruns:0 frame:0
TX packets:14369 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20241827 (19.3 MiB)
Base address:0x1000
EXAMPLE 2
XSCF>
xscf#0-lan#1
Link encap:Ethernet
inet addr:192.168.10.11
UP BROADCAST RUNNING MULTICAST
RX packets:54424 errors:0 dropped:0 overruns:0 frame:0
TX packets:14369 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20241827 (19.3 MiB)
Base address:0x1000
EXAMPLE 3
XSCF>
xscf#0-if
Link encap:Ethernet
Displays the information for XSCF-LAN#0 on XSCF unit 0.
shownetwork xscf#0-lan#1
HWaddr 00:00:00:12:34:56
Displays the information for XSCF-LAN#1 on XSCF unit 0 in the M3000/
M4000/M5000 server.
shownetwork lan#1
HWaddr 00:00:00:12:34:56
Displays the information for ISN on the XSCF unit 0.
shownetwork xscf#0-if
HWaddr 00:00:00:12:34:56
Bcast: 192.168.10.255
MTU:1500
Metric:1
TX bytes:2089769 (1.9 MiB)
Bcast: 192.168.10.255
MTU:1500
Metric:1
TX bytes:2089769 (1.9 MiB)
shownetwork(8)
Mask:255.255.255.0
Mask:255.255.255.0
System Administration
409