Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 298
Xscf control package (xcp) 109x
Hide thumbs
Also See for SPARC Enterprise M3000:
- Xscf reference manual (560 pages) ,
- Service manual (202 pages) ,
- Product notes (144 pages)
Table of Contents
Advertisement
settimezone(8)
EXTENDED
DESCRIPTION
276
SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised August 2009
-t date [/time]
Specifies the termination time of Daylight Saving Time. It should
be specified in the same format as date in the -f option. You can
specify date in any of the following formats.
Mm.w.d
Jn
n
In time, you specify the time. You can specify it in the following
format.
hh:mm:ss
You cannot specify the years of validity for time zone and Daylight Saving Time.
■
In case the Daylight Saving Time is changed each year, you need to set anew by
using the settimezone(8) command.
When Daylight Saving Time has been set, XSCF is not affected by the time zone.
■
The setting of Daylight Saving Time using "-c adddst" results in an error in
■
case the starting time and the termination time are set as follows:
Using the Jn or n format, and the period between the start and the termination
■
is less than two weeks
Using the Mm.w.d format, starts and terminates in the same month, and the
■
period between the start and the termination is less than two weeks
Mm: Specifies the month to terminate Daylight Saving Time.
For m, you can specify any integer from 1 to 12.
w: Specifies the week to terminate Daylight Saving Time. You
can specify the integer from 1 to 5, "1" for the first week and
"5" for the last week in the month.
d: Specifies the day of the week to terminate Daylight Saving
Time. You can specify the integer from 0 to 6, "0" for Sunday
and "6" for Saturday.
Jn: Specifies the sequential day in the year to terminate
Daylight Saving Time. You can specify the integer from 1 to
365, "1" for January 1st. It does not count the leap-year day. If
you specified 365, it corresponds to December 31st even in a
leap year.
n: Specifies the sequential day in the year to terminate
Daylight Saving Time. You can specify the integer from 1 to
365, "1" for January 2nd. It counts the leap-year day.
Specifies the time in "hh:mm:ss" format. hh is
00–23, mm is 00–59, ss is 00–60. In case
omitted, "02:00:00."
Advertisement
Table of Contents
