Settelnet - Fujitsu SPARC Enterprise M3000 Xscf Reference Manual

NAME settelnet - start or stop the Telnet service used in the XSCF network
SYNOPSIS settelnet -c {enable | disable}
settelnet -h
DESCRIPTION settelnet(8) command starts or stops the Telnet service used in the XSCF
network.
Privileges You must have platadm privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-c {enable|disable} Specify whether to start the Telnet service. One of the
-h
EXTENDED Caution – To stop the Telnet service, you must execute the rebootxscf(8)
DESCRIPTION command to reset XSCF. If you fail to reset XSCF, problems might occur when you
start the Telnet service next time.
■
■
■
EXAMPLES
EXAMPLE 1
EXAMPLE 2
In the M8000/M9000 servers, the setting automatically reflected to the standby
XSCF. When there's a defect on the standby XSCF, it leads to an error and the
setting will be reflected to the active XSCF only.
Stop of the Telnet service is reflected immediately after the settelnet(8)
command executed. Any open Telnet sessions are terminated.
Using the showtelnet(8) command, you can check the current settings of the
Telnet service.
Starts the Telnet service.
settelnet -c enable
XSCF>
Stops the Telnet service.
settelnet -c disable
XSCF>
Please reset the XSCF by rebootxscf to apply the telnet settings.
following values can be specified. If none of them is
specified, an error occurs.
Starts the Telnet service.
enable
Stops the Telnet service.
disable
Displays usage statement. When used with other options
or operands, an error occurs.

settelnet(8)

System Administration 269