Fujitsu SPARC Enterprise M3000 Xscf Reference Manual page 126

poweroff(8)
EXTENDED
DESCRIPTION
EXAMPLES
104 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised August 2009
When the command is executed, a prompt to confirm execution of the command
■
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
If the Solaris OS of the target domain is running, the poweroff(8) command
■
processing is equivalent to that of the shutdown(1M) command with the "-i5"
option specified.
A domain cannot be powered off while the Solaris OS of the domain is booting.
■
Execute the poweroff(8) command again after the booting is completed.
A domain cannot be powered off by the poweroff(8) command while the
■
Solaris OS of the domain is running in single-user mode. Execute the
shutdown(1M) command in the domain.
When the poweroff(8) command is executed, power-off results for each of the
■
specified domains are displayed in the following format:
The power was turned off normally.
Powered off
An error occurred, and the power could not be turned off. An
Not Powering
error message is displayed with "Not Powering off."
off
The showdomainstatus(8) command can be used to check the power of each
■
domain on the system is off.
Turns off power to all domains.
EXAMPLE 1
poweroff -a
XSCF>
DomainIDs to power off:00,01,02,03
y
Continue? [y|n]:
00:Powering off
01:Powering off
02:Powering off
03:Powering off
*Note*
This command only issues the instruction to power-off.
The result of the instruction can be checked by the "showlogs power".