Setroute - Fujitsu SPARC Enterprise M3000 Xscf Reference Manual

NAME setroute - set routing information for an XSCF network interface
SYNOPSIS setroute -c {add | del} -n address [-m address] [-g address] interface
setroute -h
DESCRIPTION setroute(8) command sets routing information for an XSCF network interface.
Up to eight routing information items can be registered for each network interface.
Any attempt to register more than eight items causes an error.
You must have platadm privilege to run this command.
Privileges
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-c {add|del}
-g address
Specifies a function for routing information. One of the following
values can be specified. If none of them is specified, an error
occurs.
Adds routing information.
add
Deletes routing information.
del
Specifies a gateway address used for routing. The specified value
of address is a set of four integer values delimited by the "."
(period). If this option is omitted, the gateway address is not
set.The following address form is accepted:
xxx.xxx.xxx.xxx
xxx An integer from 0–255. Zero suppression can
be used to specify the integer.

setroute(8)

System Administration 235