Applynetwork - Fujitsu SPARC Enterprise M3000 Xscf Reference Manual

NAME applynetwork - reflect the information that has been set for the XSCF network
SYNOPSIS applynetwork [ [-q] -{y|n}] [-M]
applynetwork -h
DESCRIPTION applynetwork(8) command reflects the information that has been set for the XSCF
network to XSCF.
When you set one of the following for the XSCF network, it is necessary to execute
the applynetwork(8) command to reflect the information to XSCF.
■
■
■
■
■
When you execute the applynetwork(8)command, it displays the information
which has been set to XSCF host name, DNS domain name, name server, IP
address, net mask, and routing. After reflected the information of XSCF network,
use the rebootxscf(8) command to reset XSCF, to complete the setting.
Note – If XSCF is reset without executing the applynetwork(8) command,
network information that is set is not reflected in XSCF. Also, information that is set
is deleted.
You must have platadm privileges to run this command.
Privileges
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-h
-M
-n
-q
-y
EXTENDED
■
DESCRIPTION
XSCF host name
DNS domain name
IP address
netmask
routing
Displays usage statement. When used with other options or
operands, an error occurs.
Displays text by page. This option provides a function that is the
same as that of the more command.
Automatically answers "n" (no) to all prompts.
Suppresses all messages to stdout, including prompts.
Automatically answers "y" (yes) to all prompts.
When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.

applynetwork(8)

System Administration 17