Setnetwork - Fujitsu SPARC Enterprise M3000 Xscf Reference Manual

NAME setnetwork - set or remove an XSCF network interface
SYNOPSIS setnetwork [-m addr] interface address
setnetwork -c {up | down} interface
setnetwork [ [-q] -{y|n}] -r interface
setnetwork -h
DESCRIPTION setnetwork(8) command sets or removes an XSCF network interface.
The following settings can be made for the specified network interface:
■
■
■
When you set an IP address or netmask, the specified network interface will be
enabled at the same time as the setting.
When you removed the netmask interface, the specified network interface will be
disabled at the same time as the removal. And when the routing information is set
to the target network interface, it will be removed together.
You must have platadm privileges to run this command.
Privileges
Refer to setprivileges(8) for more information.
Whether to enable or disable the network interface.
IP address
Netmask

setnetwork(8)

System Administration 215