Rebootxscf - Fujitsu SPARC Enterprise M3000 Xscf Reference Manual

NAME rebootxscf - reset the XSCF
SYNOPSIS rebootxscf [ [-q] -{y|n}]
rebootxscf -h
DESCRIPTION The rebootxscf(8) command resets the XSCF.
In the M8000/M9000 servers, both of the active XSCF and the standby XSCF will be
reset.
You must have platadm or fieldeng privilege to run this command.
Privileges
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-h
-n
-q
-y
EXTENDED
■
DESCRIPTION
■
■
■
EXAMPLES
EXAMPLE 1
Displays usage statement. When used with other options or
operands, an error occurs.
Automatically answers "n" (no) to all prompts.
Suppresses all messages to stdout, including prompts.
Automatically answers "y" (yes) to all prompts.
When the command is executed, a prompt to confirm execution of the command
is displayed. Enter "y" to execute the command or "n" to cancel the command.
The rebootxscf(8) command terminates all connection to XSCF, such as telnet
or ssh.
When you cancel the XSCF reset using the setdate(8) which commands reset
XSCF automatically, even if you perform this command, the information that is
set is not applied in XSCF.
By using the rebootxscf(8) command, you can reset XSCF while the domain is
in operation. However, if you set up XSCF to serve as the upper NTP server of
the domain, time lag may arise between XSCF and the domain. In such a case,
adjust the domain time so that XSCF and the domain will be synchronized.
Resets the XSCF.

rebootxscf

XSCF>
The XSCF will be reset. Continue? [y|n]:
y
System Administration
rebootxscf(8)
117