Continuous Forms
3 mm (0.12 in)
cut
1 mm (0.04 in)
uncut
C
Vertical
perforations
7-6
The uncut dimension at C on each end of horizontal perforations
shown below must be 1 mm or more.
When a cross-point cut occurs at the juncture of vertical and horizontal
perforations, printing is inhibited in the shaded area shown in the
figure below. Printing is not allowed in this area to prevent damage to
forms and also to prevent printer faults.
3 mm
(0.12 in)
3 mm
28 mm
(0.12 in)
(1.1 in)
Cross-point cut
Notice:
This restriction also applies when the print head moves without
printing.
Vertical perforations (middle)
Horizontal perforations
Edge
C
Inhibited area
Cross-point cut
28 mm
(1.1 in)
Cut
1 mm (0.04 in) or more
Uncut
Cross-point uncut
User's Manual