Table of Contents
Advertisement
MENU 1 or MENU2
Options
item
<CHR-SET>
SET 1
SET 2
*3
ITALIC
GRAPHIC
*4
<AGM>
OFF
ON
<PRF-SKP>
SKIP
NO-SKIP
<WIDTH>
13.6 IN
11.4 IN
11.0 IN
8.0 IN
<ZEROFNT>*2
NO-SLSH
SLASH
User's Manual
Table 8–3 MENU1 and MENU2 options (Continued)
Description
IBM character set 1
IBM character set 2
If a downloaded (soft) font is used, the character set for
that font overrides the <CHR-SET> setting.
Italic characters possible
Graphics characters (ruled lines) possible
Specifies that alternate graphics mode (AGM) is off.
The unit of line spacing is 1/72 or 1/216 of an inch.
Specifies that alternate graphics mode (AGM) is on.
The unit of line spacing is 1/60 or 1/180 of an inch.
For continuous forms, specifies whether an inch is
skipped over the perforation. If not using software to
specify a bottom margin, select SKIP when using thick
multipart forms.
One inch is skipped over the perforation.
The perforation is not skipped. Printing continues in
the bottom margin of the page.
13.6-inch page width
11.4-inch page width
11-inch page width
8-inch page width
Specifies whether the number zero is printed with a
slash. The slash is useful for distinguishing the capital
letter "O" from the number "0."
This setting is invalid for some software fonts.
0
Ø
Changing MENU1 and MENU2 Options
SETUP MODE
8-19
Advertisement
Table of Contents
