Table of Contents
Advertisement
<Font>
<Qual>
PICA 10
REPORT
Enter
<Menu>
setup
MENU1
Enter
<Menu>
setup
MENU2
Form
Tear off
feed
paper
User's Manual
5. Press F3 repeatedly to scroll through the various
character spacing options, selecting each in turn.
<Pitch>
12 CPI
• 10 CPI, 12 CPI, 15 CPI, 17 CPI, 18 CPI, 20
CPI, PROP SP (proportional spacing), 2.5 CPI,
3 CPI, 5 CPI, and 6 CPI
After the changes in this example, the printer prints characters using
the pica 10 font, report quality, and 12 cpi so long as the computer
commands do not change these options or you do not switch the menu
(1 or 2) in the basic menus.
Important:
The actual printed font, print quality, and pitch may differ from the
settings displayed in this menu because the options displayed are
independent of those specified by commands from the computer.
Selecting MENU1 or MENU2
You can easily select either of the two setup menus, which you can use
to change settings while in setup mode.
To select MENU1 or MENU2:
1. Make sure the printer has printed all data. Press
<Lock>
NEXT DISPLAY repeatedly until the menu
OFF
shown at the left appears.
2. To switch to MENU2, press F2.
<Lock>
OFF
3. The printer is initialized 2 seconds later. The orig-
Line
inal basic menu reappears.
feed
Important:
Print data buffer is cleared even if the last selected menu is the same as
the original.
Getting Acquainted with the Control Panel
USING THE
LCD/LED TYPE
CONTROL PANEL
E-11
Advertisement
Table of Contents
