Dell PowerConnect B-RX Configuration Manual page 128

3
Flash memory and PCMCIA flash card file management commands
•
NOTE
The copy options require you to explicitly specify the flash card. Therefore, you can perform a copy
regardless of the flash card that currently has the management focus.
Copying files from one flash card to the other
To copy a file from one flash card to the other, enter the following command.
BigIron RX# copy slot1 slot2 sales.cfg
Syntax: copy <from-card> <to-card> [/<from-dir-path>/]<from-name>
For the <from-card> and <to-card> parameters, you can specify slot1 or slot2.
The command shown in the example copies a file from the flash card in slot 1 to the flash card in
slot 2. In this case, the software uses the same name for the original file and for the copy.
Optionally, you can specify a different file name for the copy.
Copying files between a flash card and flash memory
To copy a file from a flash card to the primary area in flash memory, enter a command such as the
following.
BigIron RX# copy slot1 flash nmpr02200.bin primary
Syntax: copy slot1 | slot2 flash [/<from-dir-path>/]<from-name> monitor | primary | secondary
To copy a file from flash memory to a flash card, enter a command such as the following.
BigIron RX# copy flash slot2 nmpr02200.bin primary
Syntax: copy flash slot1 | slot2 <source-name> monitor | primary | secondary | startup-config
The command in this example copies a BigIron RX Series Multi-Service IronWare image file from
the primary area in flash memory onto the flash card in slot 2. In this case, the software uses the
same name for the source file and for the destination file. Optionally, you can specify a different file
name for the destination file.
Copying software image from a flash card to the flash memory
To copy the combined software image from a flash card to the flash memory, enter the following
command.
BigIron RX# copy slot1 image rx0208.bin
Syntax: copy slot1 | slot2 image <file-name>
The command in this example copies a BigIron RX Series Multi-Service IronWare image file from
the flash card in slot 1 to MP and LP of primary flash. In this case, the software uses the same
name for the original file and for the copy.
52
Load a running-config from a flash card or TFTP server into the device's running-config (loading
ACLs only)
[/<to-dir-path>/][<to-name>]
[<dest-name>]
BigIron RX Series Configuration Guide
53-1002253-01