9
Configuring LLDP
This above show commands are described in this section.
LLDP configuration summary
To display a summary of the LLDP configuration settings on the device, enter the show lldp
command at any level of the CLI.
The following shows an example report.
BigIron RX#show lldp
LLDP transmit interval
LLDP transmit hold multiplier
LLDP transmit delay
LLDP SNMP notification interval
LLDP reinitialize delay
LLDP maximum neighbors
LLDP maximum neighbors per port
Syntax: show lldp
The following table describes the information displayed by the show lldp statistics command.
This field...
LLDP transmit interval
LLDP transmit hold
multiplier
LLDP transmit delay
LLDP reinitialize delay
LLDP maximum
neighbors
LLDP maximum
neighbors per port
LLDP statistics
The show lldp statistics command displays an overview of LLDP neighbor detection on the device,
as well as packet counters and protocol statistics. The statistics are displayed on a global and
per-port basis.
The following shows an example report.
274
: 10 seconds
: 4
(transmit TTL: 40 seconds)
: 1 seconds
: 5 seconds
: 1 seconds
: 392
: 4
Displays...
The number of seconds between regular LLDP packet transmissions.
The multiplier used to compute the actual time-to-live (TTL) value of an LLDP
advertisement. The TTL value is the transmit interval multiplied by the transmit hold
multiplier.
The number of seconds the LLDP agent will wait after transmitting an LLDP frame and
before transmitting another LLDP frame.
The minimum number of seconds the device will wait from when LLDP is disabled on a
port, until a request to re-enable LLDP on that port will be honored.
The maximum number of LLDP neighbors for which LLDP data will be retained, per
device.
The maximum number of LLDP neighbors for which LLDP data will be retained, per port.
BigIron RX Series Configuration Guide
53-1002253-01