Dell PowerConnect B-RX Configuration Manual page 283

Bigiron rx series configuration guide v02.8.00
Hide thumbs Also See for PowerConnect B-RX:
Table of Contents

Advertisement

FIGURE 12
192.168.8.12/24
Port4/4
192.168.8.11/24
To configure a standard static IP route and a null route to the same network as shown in
on page 206, enter commands such as the following.
BigIron RX(config)# ip route 192.168.7.0/24 192.168.6.157/24 1
BigIron RX(config)# ip route 192.168.7.0/24 null0 3
The first command configures a standard static route, which includes specification of the next-hop
gateway. The command also gives the standard static route a metric of 1, which causes the device
to always prefer this route when the route is available.
The second command configures another static route for the same destination network, but the
second route is a null route. The metric for the null route is 3, which is higher than the metric for
the standard static route. If the standard static route is unavailable, the software uses the null
route.
For complete syntax information, refer to
To configure a standard static route and an interface-based route to the same destination, enter
commands such as the following.
BigIron RX(config)# ip route 192.168.6.0/24 ethernet 1/1 1
BigIron RX(config)# ip route 192.168.6.0/24 192.168.8.11/24 3
The first command configured an interface-based static route through Ethernet port 1/1. The
command assigns a metric of 1 to this route, causing the device to always prefer this route when it
is available. If the route becomes unavailable, the device uses an alternate route through the
next-hop gateway 192.168.8.11/24.
BigIron RX Series Configuration Guide
53-1002253-01
Standard and interface routes to the same destination network
Two static routes to 192.168.7.0/24:
--Interface-based route through
port1/1, with metric 1.
--Standard static route through
gateway 192.168.8.11, with metric 3.
Router A
192.168.6.188/24
Port1/1
When route through interface
1/1 is available, Router A always
uses that route.
If route through interface
1/1 becomes unavailable,
Router A uses alternate
route through gateway
Router B
192.168.8.11/24.
Configuring forwarding parameters
Router C
"Configuring a static IP route"
7
192.168.6.69/24
Router D
Figure 11
on page 201.
207

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bigiron rx series

Table of Contents