Displaying Sstp Information - Dell PowerConnect B-RX Configuration Manual

12
IEEE Single Spanning Tree (SSTP)
The commands shown above override the global setting for STP priority and set the priority to 10 for
port 1/1.
Here is the syntax for the global STP parameters.
Syntax: [no] spanning-tree single [forward-delay <value>]
Here is the syntax for the STP port parameters.
Syntax: [no] spanning-tree single [ethernet <slot>/<portnum> path-cost <value> | priority
For the parameter definitions and possible values, refer to
page 329.
NOTE
Both commands listed above are entered at the global CONFIG level.
Also, you can use the rstp single command to control the topology for VLANs. Refer to
disabling RSTP on a single spanning tree"

Displaying SSTP information

To verify that SSTP is in effect, enter the following commands at any level of the CLI.
BigIron RX(config)# show spanning-tree
VLAN 4095 - STP instance 0
--------------------------------------------------------------------
STP Bridge Parameters:
Bridge
Identifier
hex
8000000480a04000 20
RootBridge
Identifier
hex
8000000480a04000 0
STP Port Parameters:
Port
Num
1/3
1/13
SSTP members: 10 20 30 99 to 100
For information on the command syntax, refer to
342
[hello-time <value>] | [maximum-age <time>] | [priority <value>]
<value>]
Bridge Bridge Bridge Hold
MaxAge Hello
sec sec
2
RootPath
Cost
Prio Path State
rity Cost
128 4 DISABLED
128 4 DISABLED
on page 386.
LastTopology Topology
FwdDly Time Change
sec sec sec
15 1 0
DesignatedBridge Root
Identifier Port
hex
8000000480a04000 Root
Designat- Designated
ed Cost Root
0 0000000000000000 0000000000000000
0 0000000000000000 0000000000000000
"Displaying STP information"
"Default STP port parameters"
Change
cnt
0
Max Hel Fwd
Age lo Dly
sec sec sec
20 2 15
Designated
Bridge
on page 332.
BigIron RX Series Configuration Guide
on
"Enabling or
53-1002253-01