Uplink Failure Detection (UFD)
Overview
Uplink failure detection (UFD) provides detection of the loss of upstream connectivity and, if used
with network interface controller (NIC) teaming, automatic recovery from a failed link.
Commands
The UFD commands described in this chapter are:
•
•
•
•
•
•
•
•
•
•
•
clear ufd-disable
Re-enable one or more downstream interfaces on the switch/router that are in a UFD-disabled error
state so that an interface can send and receive traffic.
Syntax
clear ufd-disable {interface interface | uplink-state-group group-id}
clear ufd-disable
debug uplink-state-group
description
downstream
downstream auto-recover
downstream disable links
enable
show running-config uplink-state-group
show uplink-state-group
uplink-state-group
upstream
36
Uplink Failure Detection (UFD) | 645