Interface Port-Channel - Dell Force10 MXL Blade Reference Manual
Ftos command line reference guide for the mxl 10/40gbe switch io module
Hide thumbs
Also See for Force10 MXL Blade:
- Configuration manual (690 pages) ,
- Deployment manual (89 pages) ,
- Getting started manual (38 pages)
Table of Contents
Advertisement
Command Modes
PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command
Version 8.3.16.1
History
Example
Figure 14-39. group Command Example
FTOS(conf)#port-channel failover-group
FTOS(conf-po-failover-grp)#group 1 port-channel 1 port-channel 2
FTOS(conf-po-failover-grp)#
Related
port-channel failover-group
Commands
show interfaces port-channel
interface port-channel
Create a Port Channel interface, which is a link aggregation group containing up to 16 physical
interfaces on an MXL Switch.
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number command.
Parameters
channel-number
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
Version 8.3.16.1
History
Example
Figure 14-40. interface port-channel Command Example
FTOS(conf)#int port-channel 2
FTOS(conf-if-po-2)#
Usage
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by configuring
Information
port-channel with switchport command) or Layer 3 mode (by configuring an IP address). You can add
a Port Channel in Layer 2 mode to a VLAN.
A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on the first interface
configured in the Port Channel and enabled, FTOS determines if the Port Channel uses 100 Mb/s or
1000 Mb/s as the common speed. Refer to
If the stack unit is in a Jumbo mode chassis, then the
The Link MTU and IP MTU values configured on the channel members must be greater than the Link
MTU and IP MTU values configured on the Port Channel interface.
Introduced on MXL 10/40GbE Switch IO Module
For a Port Channel interface, enter the keyword
number:
Range: 1-128
Introduced on MXL 10/40GbE Switch IO Module
Note:
In a Jumbo-enabled system, all members of a Port Channel must be configured with the
same link MTU values and the same IP MTU values.
Accesses the PORT-CHANNEL FAILOVER-GROUP mode to configure
a LAG failover group.
Displays information on configured Port Channel groups.
channel-member
mtu
and ip mtu commands can also be configured.
port-channel
followed by a
for more information.
Interfaces | 279
Advertisement
Table of Contents
