Ip Igmp Version; Ip Igmp Snooping Enable - Dell Force10 MXL Blade Reference Manual

Parameters
Defaults
Command Modes
Command
History

ip igmp version

Syntax
Parameters
Defaults
Command Modes
Command
History

ip igmp snooping enable

Syntax
Defaults
Command Modes
Command
History
Usage
Information
230 | Internet Group Management Protocol (IGMP)
seconds
Enter the number of seconds for the maximum response time.
Default: 10 seconds
Range: 1 to 25
10 seconds
INTERFACE
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Manually set the version of the router to IGMPv2 or IGMPv3.
ip igmp version { 2 | 3 }
2
Enter the number
3
Enter the number
2 (that is IGMPv2)
INTERFACE
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Enable IGMP snooping on all or a single VLAN. This is the master on/off switch to enable IGMP
snooping.
ip igmp snooping enable
To disable IGMP snooping, enter
Disabled
CONFIGURATION
INTERFACE VLAN
Version 8.3.16.1
You must enter this command to enable IGMP snooping. When enabled from CONFIGURATION
mode, IGMP snooping is enabled on all VLAN interfaces (except default VLAN).
Note:
You must execute the
Snooping to function.
2
to set the IGMP version number to IGMPv2.
3
to set the IGMP version number to IGMPv3.
no ip igmp snooping enable
Introduced on MXL 10/40GbE Switch IO Module
no shutdown command on the VLAN interface for IGMP
command.