Simple Network Management Protocol (SNMP)
and Syslog
Overview
This chapter contains commands to configure and monitor the simple network management protocol
(SNMP) v1/v2/v3 and Syslog. The chapter contains the following sections:
•
•
SNMP Commands
The SNMP commands available in the Dell Force10 operating software (FTOS) are:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
The SNMP is used to communicate management information between the network management
stations and the agents in the network elements. FTOS supports SNMP versions 1, 2c, and 3,
supporting both read-only and read-write modes. FTOS sends SNMP traps, which are messages
informing an SNMP management system about the network. FTOS supports up to 16 SNMP trap
receivers.
SNMP Commands
Syslog Commands
show snmp
show snmp engineID
show snmp group
show snmp user
snmp ifmib ifalias long
snmp-server community
snmp-server contact
snmp-server enable traps
snmp-server engineID
snmp-server group
snmp-server host
snmp-server location
snmp-server packetsize
snmp-server trap-source
snmp-server user
snmp-server view
snmp trap link-status
Simple Network Management Protocol (SNMP) and Syslog | 579