Show Ip Interface - Dell Force10 MXL Blade Reference Manual

show ip interface

Syntax
Parameter
Command Modes
Command
History
Example
312 | IPv4 Routing
View IP-related information on all interfaces.
show ip interface [interface | brief ] [ configuration ]
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword
from 0 to 16383.
• For the Management interface, enter the keyword
followed by zero (0).
• For the Null interface, enter the keyword
• For a Port Channel interface, enter the keyword
number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
slot/port information.
• For a VLAN, enter the keyword
brief
(OPTIONAL) Enter the keyword
whether an IP address is assigned.
configuration
(OPTIONAL) Enter the keyword
with non-default configurations only.
EXEC
EXEC Privilege
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Figure 15-13. show ip interface Command Example
FTOS#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
FTOS#
Table 15-7. show ip interface Command Example Items
Lines
TenGigabitEthernet 0/0...
Internet address...
vlan
followed by a number from 1 to 4094.
brief
to view a brief summary of the interfaces and
configuration
Description
Displays the interface's type, slot/port and physical and line protocol
status.
States whether an IP address is assigned to the interface. If one is, that
address is displayed.
Loopback
followed by a number
ManagementEthernet
null
followed by zero (0).
port-channel
followed by a
TenGigabitEthernet
fortyGigE
followed by the
to display the physical interfaces