Ip Ospf Transmit-Delay - Dell Force10 MXL Blade Reference Manual

Parameters
Defaults
Command Modes
Command
History
Usage
Information

ip ospf transmit-delay

Syntax
Parameters
Defaults
Command Modes
Command
History
log-adjacency-changes
Syntax
Defaults
Command Mode
Command
History
402 | Open Shortest Path First (OSPFv2)
seconds
Enter the number of seconds as the interval between retransmission.
Range: 1 to 3600.
Default: 5 seconds.
This interval must be greater than the expected round-trip time for a packet to travel
between two routers.
5 seconds
INTERFACE
Version 8.3.16.1
Set the time interval to a number large enough to prevent unnecessary retransmissions.
Set the estimated time elapsed to send a link state update packet on the interface.
ip ospf transmit-delay seconds
To return to the default value, use the no ip ospf transmit-delay command.
seconds
Enter the number of seconds as the transmission time. This value should be greater than the
transmission and propagation delays for the interface.
Range: 1 to 3600.
Default: 1 second.
1 second
INTERFACE
Version 8.3.16.1
Set FTOS to send a Syslog message about changes in the OSPF adjacency state.
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes command.
Disabled.
ROUTER OSPF
Version 8.3.16.1
Introduced on MXL 10/40GbE Switch IO Module
Introduced on MXL 10/40GbE Switch IO Module
Introduced on MXL 10/40GbE Switch IO Module