ethertype operator
count
byte
Defaults
Not configured
Command Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
Version 8.3.16.1
History
Related
deny
Commands
permit
IP Prefix List Commands
When an access-list is created without any rule and then applied to an interface, ACL behavior reflects
implicit permit.
Use these commands to configure or enable IP prefix lists.
•
•
•
•
•
•
•
•
clear ip prefix-list
Reset the number of times traffic met the conditions ("hit" counters) of the configured prefix lists.
Syntax
clear ip prefix-list [ prefix-name ]
Parameters
prefix-name
Command Modes
EXEC Privilege
Introduced on MXL 10/40GbE Switch IO Module
Configures a filter to drop traffic.
Configures a filter to forward traffic.
clear ip prefix-list
deny
ip prefix-list
permit
seq
show config
show ip prefix-list detail
show ip prefix-list summary
(OPTIONAL) Enter the name of the configured prefix list to clear only counters for that
prefix list, up to 140 characters long.
(OPTIONAL) To filter based on protocol type, enter one of the
following Ethertypes:
ev2
•
- is the Ethernet II frame format.
llc
•
- is the IEEE 802.3 frame format.
snap
•
- is the IEEE 802.3 SNAP frame format.
(OPTIONAL) Enter the keyword
the filter.
(OPTIONAL) Enter the keyword
filter.
count
to count packets processed by
byte
to count bytes processed by the
Access Control Lists (ACL) | 127