Table of Contents
Advertisement
User Manual
GetConfig
A.7.15
1 simnow> ehc.usage
Automation Command
log (enable | disable) {mp}
A.7.16
1 simnow> journal.usage
Automation Command
GetParam
SetParam <Super Block Size>
<Index Block Size> <Index
Levels> [ <Disk Block Size> ]
A.7.17
1 simnow> cpu.usage
Automation Command
LoadAnalyzer <analyzer_file>
[<args>]
ShowAnalyzers
EnableAnalyzer <num> <0|1>
UnloadAnalyzer <num>
MCAFault <bank>
<GenerateMCAFault(0|1)> <Status
Reg> <Address Reg>
ProductFile <FileName>
CodeGen <command> <args>
DumpProfile [<blocks-to-dump>]
A.7.17.1 Profiling in SimNow™ Technology
Here is an example use of the profiling command and its output:
240
AMD Confidential
Displays the current AMD-8111 configuration.
EHC
Enables or disables Memory (m) and PCI Configuration
(p) logging.
Journal
Returns „Super Block Size‟, „Index Block Size‟, „Index
Levels‟, „Disk Block Size‟ and „Maximum Disk Size‟.
Sets journal parameters.
CPU
Loads the analyzer „analyzer_file‟ with specified
arguments „args‟).
Shows all loaded analyzers.
Enables (1) or disables (0) analyzer specified by „num‟.
Unloads analyzer specified by „num‟.
Causes a generic MCA fault if GenerateMCAFault is
true (1) at specified Bank, AddressReg and status.
Use product file to set fuses and configure CPU and
Northbridge.
Sets or disables and enables code generator settings and
options. Command must be one of the commands shown
in Table 15-13. Args depends on the command
parameter, see Table 15-13.
This command is limited to showing a profile of blocks,
without symbols, based on the current epoch. For more
information please refer to Section A.7.17.1, "Profiling
in SimNow".
September 12
Description
Description
Description
h
, 2008
Appendix A
Advertisement
Table of Contents
