Table of Contents
Advertisement
User Manual
Automation Command
Quit
Go
Stop
Close
Open <FileName>
Modules
Running
Save [<Filename>]
RunTimeDuration <time>
GetRunTimeDuration
ModifyRegistry <key> <value>
LogConsoleEnabled
SetLogConsoleEnabled <0|1>
LogWndEnabled
SetLogWndEnabled <0|1>
LogFile
SetLogFile <filename>
LogFileEnabled
SetLogFileEnabled <0|1>
LogDevice <Device Name> <0 | 1>
LoggingEnabled <Device Name>
ErrorLogFile
SetErrorLogFile <filename>
ErrorLogFileEnabled
SetErrorLogFileEnabled <0|1>
230
AMD Confidential
See Exit.
Starts the simulation, see also Section 3.1, "Tool
Bar Buttons", on page 7.
Stops the simulation, see also Section 3.1, "Tool
Bar Buttons", on page 7. The Stop command
does not return until the simulation has in fact
stopped or the stop has failed.
Closes a BSD file that was previously opened.
Opens a BSD file.
Lists all loaded modules.
Shell.running returns „No‟ if simulation is
currently not running; otherwise it returns „Yes‟.
Saves the current system configuration to a file.
Default is "simnow.bsd"
Runs the simualtion for the given number of
microseconds and then stops the simulation.
Returns the run time duration in nanoseconds.
ModifyKey modifies and updates the given
registry key with the given value.
Shell.LogConsoleEnabled returns „disabled‟ if
console logging is disabled; otherwise it returns
„enabled‟.
Enables
Shell.SetLogConsoleEnabled 1 enables logging
and Shell.SetLogConsoleEnabled 0 disables
logging.
Returns the Log Window status. The status is
„enabled‟ or „disabled‟.
Sets the Log Window status to „enabled‟ or
„disabled‟.
Returns the current Log file name. Default is
„simnow.log‟.
Sets the Log file name.
Returns „enabled‟ if file logging is enabled
otherwise it returns „disabled‟.
Enables or disabled file logging. 0 disables file
logging, 1 enables file logging.
Enabled (1) or disables (0) device logging for
<device>.
Returns the logging status of device <Device
Name>. This automation command returns
enabled or disabled.
Returns the current Error Log file name. Default
is „simnow.errlog‟.
Sets the Error Log file name.
Returns „enabled‟ if error file logging is enabled
otherwise it returns „disabled‟.
Enables or disabled error file logging. 0 disables
error file logging; 1 enables error file logging.
September 12
Description
or
disables
Appendix A
h
, 2008
logging.
Advertisement
Table of Contents
