Cleaning The Touch Overlay - AMX AXD-CP4/PB Instruction Manual

Product Information
Specifications (Cont.)
External Buttons
Button Characters
Light Detector
Motion Sensor (PIR)
Memory
Character Support
Viewing Angle
Rear Connectors:
AXlink
RS-232
Compatibility
Operating Environment • Indoor operation at temperatures between 10
Installation kit
Enclosure
Installation Cutout
Optional Accessories

Cleaning the Touch Overlay

You should clean the touch screen overlay often. Always use clean cotton cloths, and a spray bottle
of cleaning solution consisting of 50% isopropyl alcohol and 50% water.
2
6 fixed-external backlit illuminated pushbuttons (illumination is user enabled/
disbaled via the pushbuttons illumination feature). Pushbutton assignments can
include the typical Device/Channel numbers, Flip to Page option, and String/Macro.
• Top row of four buttons - Seven characters using a 10pt Century Gothic font
• Bottom row of two buttons - Seven characters using a 7pt Century Gothic font
Photosensitive light detector for adjustment of the panel brightness.
• Proximity Infrared Detector to wake the panel when the panel is approached.
• Activation range: + 20° vertically from center and + 45° horizontally from center.
512 KB of SRAM and 2 MB of Flash for a total memory of 2.5 MB
(only 2 MB is available for buttons, icons, bitmaps, and fonts).
®
Unicode character support for far-eastern languages such as Chinese.
Characters for middle-eastern languages such as Arabic are not supported within
the Unicode fonts because they are bi-directional. Buttons with Unicode fonts can
only be created and edited using TPDesign3 and NetLinx Studio. Refer to the
respective manuals for additional information.
• Horizontal viewing angle: + 50°
• Vertical viewing angle: + 50°
4-pin bus connector for connection to the AMX Central Controller.
DB-9 male connector for data transmission or Microsoft
Axcess, NetLinx, and Landmark systems (AXlink is the most common control
standard for this system)
humidity range of 5% to 90% RH (non-condensing)
• 4-pin AXlink data/power connector
• Drywall clip set (2 -drywall clamps and 2- #8 (2" long) screws
• 4-#4-40 machine screws and threaded inserts
• Metal sub-plate and bezel with black or white matte finish
• Detachable front panel bezel
Cutout Template for the AXD/T-CP4 is available as an insert in the product
packaging and from AMX as drawing number 62-5921-02. This file provides 1:1 cut-
out dimensions for the CP4 conduit/wallbox. For a replacement cutout, please call
your AMX sales representative.
• PSN2.8 Power supply (can be used on the CP4) (FG423-17)
• PSN6.5 Power supply (recommended for use on the CP4) (FG423-41)
• CB-CP4 Conduit/wallbox (includes flanges for installation to studs during the
construction phase). (FG028-10)
• Conduit/Wallbox should only be mounted to a beam before a drywall is
installed (pre-wall).
®
mouse control.
º º º º
C (50 F) to 40 C (104 F) and a
4" Color Touch Panels