External Pushbuttons; Setting The Pushbutton Illumination - AMX AXD-CP4/PB Instruction Manual

Illumination is dependent only on the LS and corresponding light threshold. It does
not matter whether the panel is in Wake/Sleep mode or whether the Light Sensor is
set to DRM or NRM.
!
!

External PushButtons

The functionality of these illuminated external pushbuttons is like those of other touch panels. The
assignments for these pushbuttons include Device/channel numbers, Flip to Page options, and a
string/macro option. The properties for these buttons is set from the
PROPERTIES
Reference instruction manual for more information on working with the firmware.

Setting the pushbutton illumination

The external pushbuttons are backlit via the illumination buttons on the Sensor Setup page of the
touch panel. The user can choose from five different illumination modes from a combination of the
three lower buttons on the Adjust Sensors page:
Refer to page 21 through page 23 for more information on these modes.
To activate the Button Illumination modes:
1. Press
2. Press the combination of the three illumination buttons that correspond to the method of
desired illumination.
The above mentioned illumination modes are also set through the use of AXlink Send_Commands.
Refer to the System Send_Commands section on page 27.
4" Color Touch Panels
BUTTON ILLUMINATION
(Off). An adjustment to this mode is also achieved through the use of the PBIL AXlink
Send_Command. Refer to page 32 for more information.
mode is a combination of the first two automatic mode buttons (
PIR/LS AUTO
button illumination). An adjustment to this mode is also achieved through the use of the
PBIL AXlink Send_Command. Refer to page 32 for more information.
The order of precedence for illumination of the pushbuttons is PIR then LS. The
!
pushbuttons illuminate if there is PIR activity, without regard to the level of the light
sensor. The pushbuttons also illuminate if there is no PIR activity and the light
sensor level falls below its threshold value.
The order of precedence for turning Off the pushbuttons is the LS then PIR. If the
!
light sensor rises above its hysteresis (turn-on) value and there is no any activity
coming from the PIR (thirty seconds of inactivity), the buttons turn Off.
menu while in touch panel Edit mode. Refer to the G3 Firmware Design and
from the Setup page.
ADJUST SENSORS
mode sets the pushbuttons to either illuminate (On) or not
, ,
ON OFF PIR AUTO
Designing Touch Panel Pages
and
PIR
> >
EDIT BUTTON
, , and
LS AUTO PIR/LS AUTO
LS
.
23