Installation And Upgrade Of The Internal Nxt Components; Step 1: Remove The Existing Nxt Outer Housing - AMX NXT-CV10 Operation/Reference Manual

CV10 Touch Panel Accessories

Installation and Upgrade of the Internal NXT Components

Upgrading the cards within the Table Top panel involves removing the outer housing (with speaker plate),
removing the existing card, replacing it with the 802.11g upgrade, and then placing the outer housing back
onto the NXT panel, as described in the following sections.
These panels do not come factory installed with the NXA-WC802.11GCF wireless interface card. This card
must be ordered separately from AMX as part of the 802.11g upgrade kit (FG2255-07).
Do not use Ethernet cables containing mounting boots. These boots could make
removal of the Ethernet connectors (from the panel) difficult and cumbersome.

Step 1: Remove the existing NXT Outer Housing

1.
Carefully detach all connectors from the rear of the touch panel and then gently place the touch panel
LCD facedown onto a soft cloth to expose the under-side of the base (FIG. 18). This step helps prevent
scratching of the LCD.
2.
Tilt the base forward so that both the bottom surface and Housing Screws are easily accessible.
Unscrew these four Housing Screws
to remove the Circuit Board Cover
FIG. 18 Location of the attachment screws underneath an NXT-CV10 panel base
3.
While holding the outer housing and base plate at an angle (to prevent it from sliding), use a grounded
Phillips-head screwdriver to remove the four Housing Screws.
Note the location of the four plastic adhesive "feet". Once the outer housing is placed
back onto the panel, these "feet" must be placed back onto their original locations so
they can fit into their provided openings on a Battery Base.
4.
Rotate the panel back over (while gripping the entire unit and outer housing) and rest the base back onto a
flat surface.
5.
Gently tilt the LCD panel backwards to expose the Tilt Bracket/Speaker assembly (FIG. 19).
20
DO NOT REMOVE these screws
They secure the plastic base front cover.
Base
Hinge Brackets (2)
Touch Panel
10" Modero Touch Panels