Upgrading The Firmware Through An Ip Address - AMX AXD-CP4/PB Instruction Manual

FIG. 23 Select New Firmware File for download page
18. Click Download to open the Confirm Communication Settings dialog, where you can review
and confirm your Comm Settings and Target Device information before the download begins.
!
!
19. The File Transfer dialog shows the progress of the download. Click Cancel to cancel the
download.
Canceling the firmware download in mid-progress can damage the on-board
firmware.
20. Once the TSK file has been downloaded, the CP4 LCD displays the message
"*Touch To Continue*".
21. Touch anywhere on the LCD to return the CP4 to the Main page (or wait 10-seconds for the
same result).
22. Reboot the CP4 touch panel by cycling power to the unit. This step completes the firmware
upgrade procedure.

Upgrading the Firmware through an IP Address

Before beginning with this section, verify that your CP4 unit is powered and connected to the
NetLinx Master through an AXlink connection. Use this method if you can only access the
NetLinx Master through an Ethernet connection.
1. Obtain the IP Address of the NetLinx Master from your System Administrator, if you do not
have an IP Address for the Master:
!
!
4" Color Touch Panels
Click Cancel to return to the Select Axcess Firmware File dialog, to edit these settings
(if necessary).
Click OK to confirm the Comm Settings and Target Device information, and download
the selected TSK file to the specified device using the selected communications port.
Follow steps outlined in the NetLinx Studio Instruction Manual for either Obtaining or
Assigning and IP Address.
From the Online tab of the Project Navigator window, select the NetLinx Master.
Upgrading the Firmware
Selected Firmware file
Device and system number
of panel.
Control Device Platform/Address
must match the information
listed in the Master Comm
settings dialog box.
53