Mounting The Decor-Style Panel On A Flat Or Solid Surface - AMX AXD-CP4/PB Instruction Manual

14. Carefully snap-on the faceplate (A in FIG. 2 on page 3) to the main touch panel unit. Make
sure the plastic buttons are flush against the faceplate and secure.
15. Reconnect the AXlink wiring to the Central Controller. The touch panel beeps when power is
applied.

Mounting the Decor-style panel on a flat or solid surface

1. Carefully remove the Decor faceplate (A in FIG. 5) from the main AXD unit (B in FIG. 5) by
gripping the faceplate from the notches (located along the underside of the plate) and pulling
with gentle force.
Do not remove the illumination board from the main unit. Damage to any pins
prevents proper operation of the unit.
holes shown below.
depends on the
installation surface.
A - Decor
faceplate
FIG. 5 Decor-style panel installation configuration for flat /solid surfaces
2. Cut out the surface using the dimensions shown in FIG. 6. Be sure not to cut out notches for the
expansion clips (only used when mounting the panel in plasterboard). FIG. 7 shows a sample
of the CP4 (62-5921-02) cutout template used for an accurate visual reference of the cutout
dimensions.
3. Thread the incoming AXlink wiring through the cutout on the flat surface.
4. Disconnect the AXlink connector from the Central Controller and thread the terminal end of
the 4-pin AXlink cable through the circular cable knockouts provided on the wallbox.
5. Attach the data and power wiring to the touch panel.
6. Test the connection by reconnecting the AXlink connector to the Central Controller. Verify that
the panel is receiving power and functioning properly to prevent repetition of the installation.
7. Disconnect the AXlink connector from the Central Controller until installation is complete.
8. Connect the data and power wiring to the rear of the touch panel.
4" Color Touch Panels
Install the #4-40
machine screw
inserts (using
four #4 screws)
into the
Screw length
Solid surface
(can include a
wall, podium, or
other level
surface)
B - Main AXD unit consists of
the touch panel, illumination board,
and housing
Installation
5