Creating Snapshot Configuration Files; Snapshot Feature List - Alcatel-Lucent OmniSwitch AOS Release 6 Manual

Creating Snapshot Configuration Files

Creating Snapshot Configuration Files
You can generate a list of configurations currently running on the switch by using the
snapshot command. A snapshot is a text file that lists commands issued to the switch during the current
login session.
Note. A user must have read and write permission for the configuration family of commands to generate a
snapshot file for those commands. See the "Switch Security" chapter of this manual for further informa-
tion on permissions to specific command families.

Snapshot Feature List

You can specify the snapshot file so that it will capture the CLI commands for one or more switch features
or for all network features. To generate a snapshot file for all network features, use the following syntax:
-> configuration snapshot all
To generate a snapshot file for specific features, select the appropriate syntax from the following list.
Snapshot Keywords
802.1Q
aaa
aip
all
bgp
bridge
chassis
health
ip
ipms
ipv6
ipmr
ip-helper
interface
You may enter more than one network feature in the command line. Separate each feature with a space
(and no comma). The following command will generate a snapshot file listing current configurations for
the vlan, qos, and snmp command families.
-> configuration snapshot vlan qos snmp
You can verify that a new snapshot file is created by using the
directory.
page 7-10
ipx
ip-routing
linkagg
module
ntp
ospf
ospf3
pmm
policy
qos
rip
ripng
rdp
session
OmniSwitch AOS Release 6 Switch Management Guide
Working With Configuration Files
configuration
snmp
stp
system
slb
vrrp
vlan
webmgt
ls command to list all files in the /flash
July 2010