Quick Steps For Setting Up Trap Filters; Filtering By Trap Families - Alcatel-Lucent OmniSwitch AOS Release 6 Manual

Using SNMP

Quick Steps for Setting Up Trap Filters

You can filter traps by limiting user access to trap command families. You can also filter according to
individual traps.

Filtering by Trap Families

The following example will create a new user account. This account will be granted read-only privileges
to three CLI command families (snmp, chassis, and interface). Read-only privileges will be withheld from
all other command families.
1
Set up a user account named "usermark2" by executing the
-> user usermark2 password ******
2
Remove all read-only privileges from the user account.
-> user usermark2 read-only none
3
Add read-only privileges for the snmp, chassis, and interface command families.
-> user usermark2 read-only snmp chassis interface
Note. Optional. To verify the user account, enter the
here:
-> show user
User name = usermark2
Read right
Write right
Read for domains
Read for families
Write for domains
Snmp authentication = NONE, Snmp encryption = NONE
The usermark2 account has read-only privileges for the snmp, chassis, and interface command families.
4
Set up an SNMP station with the user account "usermark2" defined above.
-> snmp station 210.1.2.1 usermark2 v3 enable
Note. Optional.To verify the SNMP Management Station, enter the
display is similar to the one shown here:
-> show snmp station
ipAddress/udpPort
---------------------------+---------+--------+-------------------------------
210.1.2.1/162
The usermark2 account is established on the SNMP station at IP address 210.1.2.1.
OmniSwitch AOS Release 6 Switch Management Guide
show user
= 0x0000a200 0x00000000,
= 0x00000000 0x00000000,
= ,
= snmp chassis interface ,
= None ,
status protocol user
enable v3
July 2010
Quick Steps for Setting Up Trap Filters
user CLI command.
command. A partial display is shown
show snmp station
usermark2
command. The
page 3-5